Motorola introduced a unique vibrating belt clip that works with the low voltage battery and activates during a call alert. Low Voltage Battery With Vibrating Silent Alert Belt Clip Below are the correct model numbers for each radio: Talk time is slightly reduced but still rated for 26+ hours in digital mode. Low voltage intrinsically-safe batteries are only available for the new enhanced radios and are not interchangeable. Low Voltage UL TIA Intrinsically-Safe Batteries for MOTOTRBO Radios The battery is compatible with legacy models but at a reduced rating of 18 hours in digital and 13.5 hours when using analog. New enhanced radios are rated at 28 hours in digital mode or 21 hours if still on analog. The PMNN4493 is the best choice if you have either XPR 3000e or XPR 7000e and a mix of the older “non-e” models. MOTOTRBO Low Voltage IMPRES Battery Choices The new batteries are similar in size and use IMPRES chargers. The MOTOTRBO enhanced models ( XPR 3300e, XPR 3500e, XPR 7350e, XPR 7550e, XPR 7580e) will provide up to 28 hours on a single battery charge. Radio users who need maximum talk time will benefit from Motorola’s new low voltage IMPRES technology. Up to 28 Hours With New Low Voltage IMPRES Technology They can be obtained by calling Motorola at 1-80 prompt 1.ĭownload the Motorola Technical Notification MTN-0070-19-NA_RSM Reference MTN-0070-19-NA and original factory order number when requesting replacements. Only mics that show the failure will be replaced under the MTN warranty extension. PMMN4099 MOTOTRBO PCR XPR 3000 and XPR 7000 Series RSM’s RSM’s with the new cable will include an “L” in the model suffix when shipped.īelow are the RSM’s identified in the Motorola Technical Notification (MTN): APX 8000, APX 7000, APX 6000, APX 4000, Motorola is upgrading the cable jacket material in the near future. Motorola Remote Speaker-Microphone Models Affected Motorola recommends to dress the coil section so itĭoes not get caught on uniform accessories for optimal RSM service life. Radio users who prefer to route the mic cord behind their back and stress the cable are more likely to experience the problem. The failure typically occurs at the RSM head or radio connector end or both, but can also occur in cable middle section. Symptoms and Root Cause of the Cord Failures As a result, RSM’s that show failures will be replaced for up to 24 months after purchase. When the cord is stressed the cable could tear or fray and expose the internal wiring. A manufacturing change in jacket material caused the problem. Remote speaker-microphones cables for APX P25 and XPR MOTOTRBO DMR series radios could experience jacket failures when stressed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |